Now you can apply an easy to use great-looking coating with the increased durability and friction-fighting properties of both TEFLON fluoropolymer resin and molybdenum disulfide to any firearm or metal part in as little as 2 hours. This is not just another spray paint. Brownells TEFLON/Moly Gun Finish is an ultra-modern, thermo-set, spray-on, self-lubricating coating, chemically bonded to a phenolic-epoxy base so it's highly resistant to scratches and abrasion. Because the finish is baked on, you get some extra benefits. When the metal heats, its pores open up, allowing the TEFLON component to penetrate. On high-wear areas, like slide rails, this is vital. The coating will eventually wear away but the TEFLON will still be in the pores, lubricating and protecting. The beautiful, dense colors won't lighten, dissolve or break down under all common gun solvents. This great-looking, high-tech coating can be easily applied to any part in only minutes. The convenient, aerosol can, with its versatile cone-shaped spray, is so easy to use it's almost mistake-proof. Just degrease and abrasive-blast the part; pre-heat the part 'til it's warm to the touch, then spray on Brownells TEFLON/Moly Gun Finish; let air dry. In about 15 minutes, bake in a regular kitchen oven at 350? F. for 30 minutes. As soon as the part cools, it's completely protected from rust and ready for final assembly. Brownells TEFLON/Moly Gun Finish is perfect for restoring Military rifles and parts; coating hard-to-blue, stainless steel or aluminum parts; a quality coating that really lasts and will look great for years to come. Great "hiding" ability makes it a natural for quickly redoing those dinged and pitted working guns (after you get the rust out of the pits, of course). Use as a one-coat finish, or spray on several fine, thin coats and then bake. Extremely economical, one can will fully coat up to two long guns or four handguns! 6 oz Aerosol Spray. Must ship via a ground service.